ВЛИЯНИЕ ДОБАВОК МЕДИ НА КОРРОЗИОННО-ЭЛЕКТРОХИМИЧЕСКОЕ ПОВЕДЕНИЕ ВЫСОКОЧИСТОГО ЦИНКА В СРЕДЕ ЭЛЕКТРОЛИТА NaCl

I. N. Ganiev; S. S. Sodikova; R. Kh. Saidzoda; S. J. Alikhonova

doi:10.14529/met200402

Authors

I. N. Ganiev V.I. Nikitin Institute of Chemistry of the National Academy of Sciences of Tajikistan
S. S. Sodikova V.I. Nikitin Institute of Chemistry of the National Academy of Sciences of Tajikistan
R. Kh. Saidzoda Branch of the National University of Science and Technology “MISiS” in Dushanbe
S. J. Alikhonova Russian-Tajik Slavonic University

DOI:

https://doi.org/10.14529/met200402

Keywords:

zinc, zinc–copper alloys, potentiostatic method, NaCl environment, corrosion rate, electrochemical potentials

Abstract

Modern scientific and technological progress contributes to the development of non-ferrous metallurgy at a high rate. In the total production of non-ferrous metals, which are widely used in industry, zinc ranks fourth. Due to the specific properties, zinc and its alloys are widely used as structural sheets with them, for the manufacture of semi-finished products and shaped castings. In recent years, zinc-based alloys have been widely used for the manufacture of cast protectors used to protect marine vessels and structures from corrosion.
The expansion of the fields of use of zinc products pose new challenges for specialists engaged in the production and use of new zinc-based alloys.
One of the alloying additions of zinc alloys is copper. It is reported that copper (up to 0.6 wt.%) Increases the hardness and degrades the ductility and corrosion resistance of zinc. The copper content in wrought zinc alloys reaches up to 5.5 wt%.
Due to conflicting facts regarding the effect of copper on the corrosion resistance of zinc. In this regard, we investigated the effect of its additives up to 2.0 wt.% On the corrosion-electrochemical behavior of high-purity zinc in an electrolyte NaCl. The studies were carried out by a potentiostatic method (potential sweep rate 2 mV/s) on a PI-50-1.1 pulse potentiostat. It was found that alloying zinc with copper up to 2 wt.% Increases its corrosion resistance by 10–15%, in an electrolyte environment of NaCl. The increase in the corrosion resistance of alloys of the Pb–Cu system is accompanied by a shift in the positive direction of the ordinate of the main electrochemical potentials.

References

Kilinççeker, G., Galip, H. Electrochemical behaviour of zinc in chloride and acetate solutions. Protection of Metals and Physical Chemistry of Surfaces, 2009, vol. 45, pp. 232–240. DOI: 10.1134/S2070205109020191

Muller C., Sarret M., Benballa M. Some Peculiarities in the Codeposition of Zinc–Nickel Alloys. Electrochim. Acta, 2001, no. 46 (18), pp. 2811–2817. DOI: 10.1016/s0013-4686(01)00493-5

Rajappa S.K, Venkatesha T.V., Praveen B.M. Chemical treatment of zinc surface and its corrosion inhibition studies. Bulletin of Materials Science, 2008, vol. 31, no. 1, pp. 37–41. DOI: 10.1007/s12034-008-0007-3

Dutra C.A.M., Codaro E.N., Nakazato R.Z. Electrochemical Behavior and Corrosion Study of Electrodeposits of Zn and Zn–Fe–Co on Steel. Materials Sciences and Applications, 2012, vol. 3, no. 6, pp. 348–354. DOI: 10.4236/msa.2012.36050

Myeong H.L., Yeon W.K., Kyung M.L., Seung H.L., Kyung M.M. Electrochemical evaluation of zinc and magnesium alloy coatings deposited on electrogalvanized steel by PVD. Trans. Nonferrous Met. Soc. China, 2013, no. 23, pp. 876–880. DOI: 10.1016/s1003-6326(13)62542-x

Aliev J.N., Obidov Z.R., Ganiev I.N. Tsink-alyuminiyevyye zashchitnyye pokrytiya novogo pokoleniya. Fiziko-khimicheskiye svoystva tsink-alyuminiyevykh splavov s shchelochnozemel’nymi metallami [New generation zinc-aluminum protective coatings. Physicochemical properties of zinc-aluminum alloys with alkaline earth metals]. Germany: Ed. house LAP LAMBERT Acad. Publ., 2013. 129 p.

Obidov Z.R., Ganiev I.N. Fizikokhimiya tsink-alyuminiyevykh splavov s redkozemel’nymi metallami [Physicochemistry of zinc-aluminum alloys with rare earth metals]. Dushanbe, “Andaleb R” Publ., 2015. 334 p.

Kechin V.A., Lyublinsky E.Ya. Tsinkovyye splavy [Zinc alloys]. Moscow, Metallurgy Publ., 1986. 247 p.

Amini R.N., Obidov Z.R., Ganiev I.N., Mohamad R.B. Potentiodynamical research of Zn–Al–Mg alloy system in the neutral ambience of NaCl electrolyte and influence of Mg on the structure. Journal of Surface Engineered Materials and Advanced Technology, 2012, vol. 2, no. 2, pp. 110–114. DOI: 10.4236/jsemat.2012.22017

Amini R.N., Obidov Z.R., Ganiev I.N., Mohamad R.B. Anodic Behavior of Zn–Al–Be Alloys in NaCl Solution and the Influence of Be on Structure. Journal of Surface Engineered Materials and Advanced Technology, 2012, vol. 2, no 2, pp. 127–131. DOI: 10.4236/jsemat.2012.22020

Amini R.N., Nizomov Z., Razazi M., Ganiev I.N., Obidov Z.R. Potentiodynamical research of Zn–Al–Mg alloy system in the neutral ambience of NaCl electrolyte and influence of Mg on the structure. Oriental Journal оf Chemistry, 2012, vol. 28, no. 2, pp. 841–846. DOI: 10.4236/jsemat.2012.22017

Amini R.N., Irani M.B., Ganiev I.N., Obidov Z.R. Galfan I and Galfan II doped with calcium, corrosion resistant alloys. Oriental Journal оf Chemistry, 2014, vol. 30, no. 3, pp. 969–973. DOI: 10.13005/ojc/300307

Aliev J.N., Ganiev I.N., Narzulloev Z.F. [Influence of iron and nickel additions on the hardness of Zn5Al and Zn55Al alloys]. Polytechnic Bulletin. Engineering Research Series, 2018, no. 1 (41), pp. 85–91. (in Russ.) DOI: 10.1134/s0044461819110082

Dzhaloyev J.Kh., Ganiev I.N., Amonov I.T., Yakubov U.Sh. Anodic behavior of the Al + 2.18% Fe alloy doped with strontium in the NaCl electrolyte environment. Bulletin of the Siberian State Industrial University, 2019, no. 1 (27), pp. 42–46. (in Russ.)

Ganiev I.N., Yakubov U.Sh., Sangov M.M., Khakimov A.Kh. Anodic behavior of the AZh5K10 alloy modified with strontium in an electrolyte NaCl environment. Bulletin of the Siberian State Industrial University, 2017, no. 4 (22), pp. 57–62. (in Russ.)

Yakubov U.Sh., Ganiev I.N., Sangov M.M. Electrochemical corrosion of barium modified AZh5K10 alloy in NaCl electrolyte environment. Bulletin of the Saint Petersburg State Technological Institute (Technical University), 2018, no. 43 (69), pp. 21–25. (in Russ.)

Odinaev F.R., Ganiev I.N., Safarov A.G., Yakubov U.Sh. Stationary potentials and anodic behavior of bismuth-doped AZh 4.5 alloy. Bulletin of the St. Petersburg State Technological Institute (Technical University). 2017, no. 38, pp. 8–12. (in Russ.)

Yakubov U.Sh., Ganiev I.N., Sangov M.M., Ganieva N.I. On the corrosion potential of the AZh5K10 alloy modified with alkaline-earth metals in an electrolyte NaCl environment. Bulletin of Nosov Magnitogorsk State Technical University, 2018, vol. 16, no. 3, pp. 109–119. (in Russ.) DOI: 10.18503/1995-2732-2018-16-3-109-119

Yakubov U.Sh., Ganiev I.N., Sangov M.M., Amini R.N. Influence Addition of Calcium on Corrosion-Electrochemical Behavior of Alloy AF5S10 in Aqueous Solutions NaCl. Bulletin of the South Ural State University. Ser. Metallurgy, 2018, vol. 18, no. 3, pp. 5–15. (in Russ.) DOI: 10.14529/met180301

Ganiev I.N., Aminbekova M.S., Eshov B.B., Yakubov U.Sh., Mulloeva N.M. Anodic behavior of the lead alloy CCu3 with cadmium in the NaCl electrolyte environment. Bulletin of Kazan Technological University, 2019, vol. 22, no. 1, pp. 42–46. (in Russ.)

Berdiev A.E., Ganiev I.N., Niyozov Kh.Kh. Influence of yttrium on the anodic characteristics of the AK1M2 alloy. Izvestiya vuzov. Electronic engineering materials, 2014, vol. 17, no. 5, pp. 224–227. (in Russ.)

Idiev I.Sh., Norova M.T., Ganiev I.N., Alikhonova S.J. Electrochemical potentials of zinc alloy TsAMg4.5-2 with lanthanum, in an electrolyte NaCl environment. Bulletin of Kazan Technological University, 2019, vol. 22, no. 4, pp. 64–67. (in Russ.)