Development of a Beam-Based Finite Element Model of a Coriolis Flowmeter Verified Against Test Results
DOI:
https://doi.org/10.14529/mmph260408Keywords:
Coriolis flowmeter, finite element method, natural frequency, forced vibrations, time delay, mass flow, gyroscopic forces, mass flow, gyroscopic forcesAbstract
This paper addresses the development and verification of a beam-based finite element model for a Coriolis flow meter (CFM). The study is motivated by the need for computational models capable of accurately describing the dynamics of CFM measuring tubes, particularly during the flow of two-phase fluid. The research aimed to develop a methodology for selecting beam model parameters that simultaneously satisfy three criteria for model fidelity relative to the actual device: equality of operating frequencies, equality of Coriolis frequencies, and equality of time delays. The methodology is based on a finite element formulation of the vibration problem for a Timoshenko beam interacting with flowing fluid, accounting for gyroscopic coupling. To verify the model, flow tests were conducted on a DN15 flow meter prototype using a fixed water flow rate and varying air volume fractions. Model calibration was performed by adjusting the masses of attached components. It was found that the optimization problem has multiple solutions; improving solution accuracy requires introducing an additional variable parameter – specifically, the positioning coordinates of the side coils. The study demonstrates that the «theoretical» fluid density differs from the density displayed by the electronic unit, suggesting a non-uniform distribution of air across the tubes. However, when density and mass flow rate readings from the experimental flow meter are used in the verified model, the calculated and experimental relationships – plotting operating frequency and time delay against gas volume fraction – show near-perfect agreement; this indicates that the experimental readings reflect averaged values.Downloads
Published
2026-11-13






