On an Analytical Method for Studying the Strength of a Discrete-Continuous Heterogeneous Strip in a Particular Case of the Heterogeneity Function
DOI:
https://doi.org/10.14529/mmph260401Keywords:
plastic layer, plane strain, heterogeneous joint, welded joint, shear and normal stresses, critical states, quasilinear hyperbolic systems, Riemann invariantsAbstract
The critical states of a tensile plastic strip under plane strain are studied. The strip is discretely heterogeneous in the longitudinal direction – it contains a transverse rectangular layer made of a less strong material – and continuously heterogeneous in the transverse direction. In particular, the layer is continuously heterogeneous along its length. The heterogeneity function of the strip is even with respect to its longitudinal axis of symmetry, monotonic on each side of the axis, and depends on the distance from this axis. The research method is based on the assumption, typical for thin layers, that the shear stresses in the middle part of the layer depend linearly on the transverse coordinate of the layer (the longitudinal coordinate of the strip). This assumption made it possible to obtain, as a consequence of the original system, an ordinary differential equation for the function of the longitudinal coordinate of the strip, which is a factor in the function of the shear stresses. This equation was solved by expanding it in a power series in order to obtain an approximate analytical solution. A model form of the heterogeneity function is considered, for which explicit analytical expressions are obtained for the approximate calculation of critical values of tangential and normal stresses at the boundary between the layer and the rest of the strip material, as well as for calculating the critical load, depending on the geometric and mechanical parameters of the strip, including the layer.Downloads
Published
2026-11-13






