Stochastic model of removal allowances and formation surface in a plane grinding by periphery of the circle for automated process control

Authors

  • Anatoly Alexandrovich Koshin South Ural State University
  • Viktor Ivanovich Guzeev South Ural State University
  • Leonid Viktorovich Shipulin South Ural State University

Keywords:

grinding, modeling, process management

Abstract

Process of polished surface formation at the flat grinding by the circle periphery is considered. Automated process control is possible through a stochastic model of the removal allowance. The main development stages of model are given: modeling of a form of abrasive grain; modeling of a form of the scratch got at cutting by grain; longitudinal imposing of scratches; cross-section imposing of scratches and stochastic imposing of scratches.

Author Biographies

Anatoly Alexandrovich Koshin, South Ural State University

Doctor of Science (Engineering), Professor of Mechanical Engineering Technology Department

Viktor Ivanovich Guzeev, South Ural State University

Doctor of Science (Engineering), Professor, Dean of Mechanics and Technology Faculty

Leonid Viktorovich Shipulin, South Ural State University

post-graduate student of Mechanical Engineering Technology Department

References

Глейзер, Л.А. О сущности процесса круглого шлифования / Л.А. Глейзер // Вопросы точности в технологии машиностроения. – М.: Машгиз, 1959. – С. 5-24.

ГОСТ Р52381–2005. Материалы абразивные. Зернистость и зерновой состав шлифовальных порошков. Контроль зернового состава. – М.: Стандартинформ, 2006. – 11 с.

Дьяконов, А.А. Оценка обрабатываемости материалов в процессах шлифования: дис. ... канд. техн. наук / А.А. Дьяконов. – Челябинск, 2002. – 255 с.

Downloads

Published

2014-03-20

Issue

№23 (282), issue 16

Section

The main