THE FEEDER OF A ROTARY SNOWBLOWER BASED ON THE OPERATING CONDITIONS

D. S. Aleshkov
Siberian State Automobile and Highway University (SibADI), Omsk

P. A. Korchagin
Siberian State Automobile and Highway University (SibADI), Omsk

I. A. Teterina
Siberian State Automobile and Highway University (SibADI), Omsk

E. V. Khiryanov
Siberian State Automobile and Highway University (SibADI), Omsk


Abstract


his paper assesses the introduction and application of design solutions at the early stages of snowblower design. Analytical expressions were obtained for the volumes of snow mass cut by the horizontal and vertical cutters of the rotary snowplow feeder. The time of transporting the cut snow mass was estimated. The influence of the design and technological parameters on the size of the cut snow mass and the time of its transportation is shown. The results show the range of values in which the length of the cutting path of the snow mass for a horizontal cutter is less than the length of the cutting path for a vertical cutter.

Keywords


snowplow, rotary, snow mass, rotary snowplow feeder, efficiency, design parameters, technological parameters

Refbacks

  • There are currently no refbacks.