IMPROVEMENT OF LOADCHARACTERISTICS OF A RADIAL BEARING WITH THE COMPRESSED LUBRICANT LAYER
Keywords:
layer, gap, Reynolds's equation, density, pressure, model, lubricant, Newton's method, running waveAbstract
In article the task about improvement of tribological characteristics of lubricating liquid and
gas layers of various frictional units due to forcing of the environment in a layer by peristaltic action of opposite directional traveling waves of fluctuations is considered. The model of a current
of liquid in a gap with waveforming surfaces in the presence in it liquid with various size of content of gas and, including, pure gas and incompressible liquid is considered. As the main object
of a research the cylindrical layer is chosen. In this case it is possible to study separately a rigidity
and delivery characteristics of a standard selfcontained layer.
By drawing up mathematical model the main assumptions of the theory of hydrodynamic
lubricant are accepted, at the same time temperature effect and accounting of compressibility of lubricant is carried out by introduction to model of defining temperature and padding parameter of gas content.
It is shown that action of traveling waves in a layer defines emergence of a radial and angular
rigidity which repeat similar dependences of the routine cylindrical vibrobearing layer with
the uniform vibration squeezing of the compressed lubricant. Additive rotation of the surfaces,
limiting a layer, with rather high angular velocity leads to emergence of developed hydrodynamic
effect, which in a combination with forcing of lubricant from action of a traveling wave leads
to emergence of combinational multiplicative effects. In particular, in a frequency range of
a traveling wave in which the maximum of the forced pressure is observed there is an essential
increase in a rigidity and bearing capacity of a lubricating layer. The similar multiplicative effect
arises from a combination of effect of forcing of lubricant and vibration squeezing of a layer, et al.
References
Pan, C. N. T. An Asymptotic Analysys of Gaseous Squeeze-Film Bearing / C. N. T. Pan // Journal of Lubrication Technology: Trans. ASME; Ser. F. – 1967. – Vol. 89, No. 3. – P. 245–253.
Constantinescu, V.N. Gas Lubrication // The American Society of Mechanical Engineers. – New York, 1969. – 709 p.
Пат. 2121612 РФ, МКИB 05 B 17/04. Ультразвуковой газовый компрессор и ороситель на его основе/ С.Г. Некрасов и др.; заявитель и патентообладатель Юж.-Урал. гос. ун-т. – №93032626/06; заявл. 05.04.1998, опубл. 10.11.98, Бюл. 31.– 9 с.
Некрасов, С.Г. Нетрадиционные задачи теории тонкого слоя сжимаемой жидкости с вибрацией/ С.Г. Некрасов, А.С. Филимонов, Н.А. Пашнина// XXVI Российская школа по пробле-мам науки и технологий. – Екатеринбург, 2006. – С. 86–88.
Nekrasov, S.G. The profiling effect on the characteristics of gas flow in fine vibrating clearances / S.G. Nekrasov, N.A. Pashnina // Journal of Friction and Wear. – 2010. – Vol. 31, no. 3. – P. 171–179.
Модерау, П.В. Эффект увеличения среды в зазорах с бегущей волной/ П.В. Модерау// Труды Всесоюзной конференция по газовым подшипникам турбомашин. – 1975. – С. 15–19.
Nekrasov, S.G. To the Projection of a PeristalticSlit Pump / S.G. Nekrasov // Procedia Engineering. – 2016. – Vol. 150. – P. 506–513.
Nekrasov, S.G. Hydrodynamic Seal on the Basis of a Cylindrical Layer of the Compressible Fluid with a Running Wave / S.G. Nekrasov // Procedia Engineering. – 2016. – Vol. 150. – P. 514–519
Канторович, Л.В. Функциональный анализ/ Л.В. Канторович, Г.П. Акилов. – М.: Наука, 1977. – 741 c.
Самарский, А.А. Теория разностных схем/ А.А. Самарский. – М.: Наука, 1983. – 616 c.
Самарский, А.А. Разностные методы решения задач газовой динамики/ А.А. Самарский, Ю.П. Попов. – М.: Наука, 1978. – 589 с.
Самарский, А.А. Методы решения сеточных уравнений/ А.А. Самарский, Е.С. Николаев. – М.: Наука, 1977. – 537 с.
Прецизионные газовые подшипники/ И.Е. Сипенков, А.Ю. Филиппов, Ю.Я. Болдырев и др.; под ред. А.Ю. Филиппова и И.Е. Сипенкова. – СПб.: ГНЦ РФ ЦНИИ«Электроприбор», 2007. – 504 с.
Zadorozhnaya, E. Study of HTHS Viscosity of Modern Motor Oils / E. Zadorozhnaya, I. Levanov, et al. // Procedia Engineering, 2016. – Vol. 150. – P. 602–606.
Mukchortov, I.V. The Influence of Anti-Wear Additives on the Bearings Hydro-Mechanical Characteristics / I.V. Mukchortov, K.A. Pochkaylo,et al. // Procedia Engineering. – 2016. – Vol. 150. – P. 607–611.
Zadorozhnaya, E.A. Solving a thermohydrodynamic lubrication problem for complex-loaded sliding bearings with allowance for rheological behavior of lubricating fluid / E.A. Zadorozhnaya // Journal of Machinery Manufacture and Reliability. – 2015. – Vol. 44. – Iss. 1. – P. 46–56.
Levanov, I.G. Methods of assessing the resourceof the crankshaft bearing of internal combustion engine based on the calculation of hydro-mechanical characteristics / I.G. Levanov, A.L. Dudnikov, et al. // Tribology in Industry. – 2015. – Vol. 37. – Iss. 3. – P. 360–365.
Mukchortov, I. The influence ofpoly-molecular adsorption on the rheological behaviour of lubricating oil in a thin layer / I. Mukchortov, K. Pochkaylo, et al. // FME Transactions. – 2015. – Vol. 43. – Iss. 3. – P. 218–222.
Rozhdestvensky, Y. A simulation of the thermal state of heavily loaded tribo-units and its evaluation / Y. Rozhdestvensky, E. Zadorozhnaya // Bulletinof the South Ural State University, Series: Mathematical Modelling, Programming and Computer Software. – 2014. – Vol. 7. – Iss. 4. – P. 51–64.
Блехман, И.И. О«вибрационной механике» и вибрационной технике/ И.И. Блехман. – М.: Наука, 1988. – 208 c.
