Development of the sensorless digital control system of electric drive based on double inverter-fed induction motor

Authors

  • M. A. Bobrov National Research Ogarev Mordovia State University, Saransk
  • I. S. Yushkov National Research Ogarev Mordovia State University, Saransk
  • G. M. Tutaev National Research Ogarev Mordovia State University, Saransk
  • I. V. Gulyaev National Research Ogarev Mordovia State University, Saransk

DOI:

https://doi.org/10.14529/power170311

Keywords:

double inverter-fed induction motor, sensorless control, PI-controller, speed observer, frequency.

Abstract

In the article the results of theoretical and experimental research of the electric drive based on double
inverter-fed induction motor operation mode using a novel sensorless digital control system to improvement and elimination of previous control systems options disadvantages for this type of electric drive are presented. The structure of a speed observer for an electric drive based on double inverter-fed induction motor using PI-controller is proposed. Unlike well-known speed observers structures used in AC drive control systems, the proposed rotor speed observer for double inverter-fed induction motor is independent on the base machine parameters and isn’t contained it in the speed calculation algorithms, which are depending on the operating mode of the electric drive and has better dynamic characteristics from previous control system options. The evaluation of the angular rotor speed observation accuracy in the range from the initial to the nominal va­lues is given.

Author Biographies

M. A. Bobrov, National Research Ogarev Mordovia State University, Saransk

-

I. S. Yushkov, National Research Ogarev Mordovia State University, Saransk

-

G. M. Tutaev, National Research Ogarev Mordovia State University, Saransk

-

I. V. Gulyaev, National Research Ogarev Mordovia State University, Saransk

-

References

Chen Z., Cai X., Kennel R., Wang F. Enhanced Sensorless Control of SPMSM Based on Stationary Refe¬rence Frame High-Frequency Pulsating Signal Injection. IEEE 8th International Power Electronics and Motion Control Conference (IPEMC-ECCE Asia 2016), pp. 885–890. DOI: 10.1109/IPEMC.2016.7512403

Cheema M.A.M., Fletcher J.E., Xiao D., Rahman F. Sensorless Control of Linear Permanent Magnet Synchronous Motors Using a Combined Sliding Mode Adaptive Observer. IEEE Energy Conversion Congress and Exposition (ECCE), September 2014, pp. 4491–4498. DOI: 10.1109/ECCE.2014.6954016.

Jianhui Hu, Jibin Zou, Fei Xu, Yong Li, Yanchao Fu. An Improved PMSM Rotor Position Sensor Based on Linear Hall Sensors. Proc. IEEE PESC Conf. Rec, 2012, рр. 3591–3594. DOI: 10.1109/TMAG.2012.2202279.

Deenadayalan A., Ilango G.S. Position Sensorless Sliding Mode Observer with Sigmoid Function for Brushless DC Motor. Advances in Power Conversion and Energy Technologies (APCET), August 2012, pp. 1–6. DOI: 10.1109/APCET.2012.6302028.

Litvinov B.V., Davydenko O.B. Standard Links and Cascade Equivalent Circuits of Electric Machines, Monograph, Novosibirsk, NSTU Publishers, 2008. 215 р.

Isakov А.S. [Squirrel-Cage Induction Motor States Observer Implementation in Sensorless Flux Vector Control System]. Bulletin of St.P ITMO. Ser. Control Technology, 2007, vol. 38, pp. 280–286. (in Russ.)

Lee K.-W., Ha J.-I. Evaluation of Back-EMF Estimators for Sensorless Control of Permanent Magnet Synchronous Motors. Journal of Power Electronics, 2012, vol. 12, no. 4, pp. 604–614 DOI: 10.6113/JPE.2012.12.4.604

Schauder C. Adaptive Speed Identification for Vector Control of Induction Motor Without Rotational Transducers, IEEE Trans. Industry Applications, 1992, vol. 28, no 5, pp. 1054–1061. DOI: 10.1109/28.158829

Vinogradov A.B., Sibircev A.N., Kolodin I.Yu. [Adaptive Flux Vector Control System of Sensorless

Induction Drives EPV Series]. Power Electronics, 2006, no. 3, pp. 46–51. (in Russ.)

Saihi L., Boutera A. Robust Sensorless Sliding Mode Control of PMSM with MRAS and Luenberger

Extended Observer. 2016 8th International Conference on Modelling, Identification and Control (ICMIC 2016), 2016, pp. 48–57. DOI: 10.1109/ICMIC.2016.7804294

Afanasiev K.S., Glazyrin A.S. [Identification of the Induction Motor Speed at Laboratory Bench Using the Kalman Filter and Luenberger Observer]. Electrical Engineering Complexes and Control Systems, 2012, no. 4, pp. 66–69. (in Russ.)

Tutaev G.M. Algoritmy energoeffektivnogo upravleniya asinkhronizirovannym ventil'nym dvigatelem

[Energy-Efficient Control Algorithms of Double Inverter-Fed Induction Motor]. Saransk, Ogarev Mordovia State University Publ., 2014. 100 p.

Gulyaev I.V., Tutaev G.M., Yushkov I.S. Inverter-Bed Induction Motor Power Supplied by Voltage Inverter. Russian Electrical Engineering, 2011, vol. 82 (2), pp. 80–82. DOI: 10.3103/S1068371211020076

Tutaev G., Bobrov M. Rotor Speed Estimation in Control System of Electric Drive Based on Induction Inverter-Fed Motor. Proceedings of the 2016 IX International Conference on Power Drives Systems (ICPDS), October 2016, pp. 1–4. DOI: 10.1109/ICPDS.2016.7756689

Shreyner R.T. Matematicheskoe modelirovanie elektroprivodov peremennogo toka s poluprovodnikovymi preobrazovatelyami chastoty [Mathematical Simulation of AC Drives with Semiconductor Frequency Converter]. Ekaterinburg, UrО RАS Publ., 2000. 654 p.

Ben Ali A., Abdelati R., Mimouni Faouzi M., Dhifaoui R. Maximum-Torque and Maximum-Efficiency Rotor Flux Selection of an Induction Motor in Transient Regime. International Journal of Sciences and Techniques of Automatic Control & Computer Engineering (IJ-STA), 2010, vol. 4, no. 2, pp. 187–196.

Mesheryakov V.N., Bezdenegnykh D.V. [Flux Linkage Observer for Doubly-Fed Induction Motor

Supplied at Stator and Rotor Circuits]. Bulletin of Voronezh state technical university, 2010, vol. 6, no. 11,

pp. 170–173. (in Russ.)

Pankratov V.V., Zima E.A. Asynchronous Machines and Machines with a Double Power Supply. Russian Electrical Engineering, 2003, vol. 72, pp. 22–29.

Vinogradov A.B. Vektornoe upravlenie privodami peremennogo toka [Flux Vector Control of AC Drives]. Ivanovo,V.I. Lenin ISPEU Publ., 2008. 298 p.

Published

2017-10-08

Issue

Section

Elecromechanical systems